Dropper operation method
1 , connect the power: AC380V 50HZ sedan five lines
2. Turn on the power switch to the ON position. ( At this time, it is forbidden for any personnel without professional training to enter the yellow cordon to do any relevant test operations, and it is forbidden to stand under the drop arm, which is very dangerous ) . The power indicator light is on and the instrument enters standby after self-test. status;
3 , set the required height, press " I △" key until J2 function table inside, set the desired height ( unit: mm) ; set the height when the place by 1 ; place by 2 ; hundred by 3 ; Press 4 ; Tensile press 5 ; Tensile press 6 ; Height setting is completed, press " I △" key continuously until the current test, standby status can be ( note that the machine has been adjusted when the instrument, in addition to its own set height , Do not change other parameters, otherwise there may be failure ) ;
4 , the height set to complete the object to be tested, placed on the test board, the fixture is completed ( Note: The test must be completed by two people) by themselves according to the required surface, angle , edge .
5. Test method: Pressing the ascending key to raise the set height will automatically stop the rise. At this time, it enters the state to be tested (the operator leaves the test area ) and presses the falling key, the test item falls freely, and the test is completed;
Remarks: If there is an emergency, please do not handle it yourself. You can notify the manufacturer or seller to avoid accidents.
Equipment technical performance
. a monoplane design automatic release large acceleration, ensuring freedom of separation of the sample carrier, the sample packing achieve free fall, the impact of small vibration, stable and reliable, is truly complete face, edge, corner drop test;
